Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Unplug the bender before changing accessories.
Accidental start-up could result in serious injury.
1. Slide the appropriate bending shoe onto the shaft
of the main sprocket, as shown. Align the four drive
studs on the back of the shoe with the four holes in
the main sprocket.
Note: 1-1/2" and 2" EMT and IMC single-groove
bending shoes have only three drive studs.
Installing a Bending Shoe
Greenlee Tools, Inc.
555C Electric Bender Classic
2. Mount the appropriate support unit onto the leg of
the bender and install the hinge pin, as shown.
Roller Support Unit Installed
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Install pin.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido