Reset Procedure - GAPOSA QCWS Manual De Instrucciones

ATTENTION: the QCWSSR radio sun/wind sensor has to be combined with a
transmitter.
First set a transmitter (QCTL) with the motor then set the transmitter with the QCWSSR
as follows:
1) press and hold simultaneously both buttons (S + W)
2) when the 9 leds start blinking in sequential mode, release the 2 buttons
3) within 8 seconds press the transmitter (QCTL) "UP" button.
4) successful reception of signal is confirmed by the blinking of all the leds together
ATTENTION: the QCWSSR radio sensor does not accept any signal during the setting
procedure (status shown by the sequential flashing of the leds) until a transmitter has
been previously set up.
IMPORTANT: Only 1 transmitter can be set with the QCWSSR radio sensor. A reset
procedure has to be performed if you want to change the transmitter already combined
with the radio sensor.

RESET PROCEDURE:

1) press and hold simultaneously both buttons (S + W)
2) when the 9 leds start blinking in sequential mode, release the 2 buttons
3) within 8 seconds press "STOP" button of any transmitter (QCTL) - not necessarily the
transmitter already combined.
4) successful reception of the signal is confirmed by the blinking of all the leds together
QCTL
BUTTON 1, 2, 3: standard functions
1 > UP
2 > STOP
3 > DOWN
BUTTON 4:
Short press: sun sensor activation/deactivation
BUTTON 5:
Light control (QCRL)
QCWSSR
EN
23
1
4 5
3