GAPOSA QCWS Manual De Instrucciones página 25

WIND SENSOR SENSIBILITY SETTINGS:
1. Press W
2. Leds 1, 2, 3, 4 and 5 show the actual setting for 8 seconds
3. press W again and select one of the 5 possible thresholds
ATTENTION: the wind sensor can never be disactivated
Setting
Low wind speed
Low/medium wind speed
Medium wind speed
Medium/high wind speed
High wind speed
The wind sensor works as follows:
- When the wind speed goes over the threshold for more than 3 seconds the radio
sensor shifts in wind warning mode and commands the motor to "CLOSE".
- During the wind warning mode led 5 blinks and the radio sensor commands every 90
seconds the motor to "CLOSE".
- When the wind speed decreases and remains below the threshold for more than 10
minutes the radio sensor leaves the wind warning mode.
This mode enables the sun sensor to send the "OPEN" command in case light intensity
is over the threshold.
Wind sensor operating led (5):
Led 5 shows the wind sensor status:
LED 5 OFF
LED 5 blinks slowly
LED 5 blinks fast
LED 1 LED 2 LED 3 LED 4 LED 5
ON OFF OFF
ON ON OFF
ON ON ON
ON ON ON
ON ON ON
the detected wind speed is below the threshold
The sensor is in wind warning mode. Detected wind speed is
over the threshold
The radio sensor is commanding the motor to "CLOSE"
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON ON
QCWSSR
EN
25
6 1
2
7
8
3
9
4
5