Publicidad
Idiomas disponibles
Idiomas disponibles
•
Frame
•
Back Brace
•
Seat
•
Lid
assembly instructions
STEP 1
Frame
STEP 2
Front Cross
Brace
Frame
Socket
STEP 3
Commode
Bucket
1.
Unfold commode and stand upright.
2.
Adjust the sides of commode frame perpendicular to the
back frame.
3.
Attach front cross brace by depressing push pins and
sliding brace into side frame socket. Attach on both
sides. Be sure push pins "snap" through holes.
4.
Attach back brace by depressing brass push pins and
sliding back brace into receptacle located on back
of cross brace. Be sure push pins "snap" through holes.
parts
•
Commode Bucket
with Lid
•
Splash Guard
Side
Frame
Back
Brace
Commode
Seat and Lid
5.
Place commode bucket into bracket and attach seat and
lid onto back of frame.
6.
To unfold, depress push pins on back support and
remove. Depress push pins on front frame and slide
frame from side.
adjusting leg height
1.
Before use, adjust height of each leg to your
specific needs, making sure all legs are at
the same height. When desired height is
reached, lock legs into place by aligning
buttons into proper holes, per illustration.
2.
To be sure legs are locked into place by
pushing down on or by pulling legs.
precautions
Weight Capacity: 350 lbs / 158 kg
1.
Toilet seat must be in down position before use.
Failure to do so may result in breakage of commode
and possible injury.
2.
Do NOT install commode without first reading and
understanding this assembly and instruction sheet. If you
can not understand these instructions, contact a health-
care dealer or technical professional before attempting
to install. Otherwise, injury or damage may occur.
3.
Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.
4.
Make certain that the height adjusting snap buttons fully
protrude through the same respective hole of each
leg extension. This will ensure that the leg extensions
are securely locked in position and an even height is
achieved (see Figure 1).
5.
Ensure ALL screws, nuts and/or bolts are tightened.
6.
Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any or
all if any of these imperfections exist.
7.
All four leg extensions with rubber tips MUST touch the
floor simultaneously at all times.
8.
Users with limited physical strength should be supervised
or assisted while using commode.
FIGURE 1
Publicidad
