Electrical Connection - Kunft KSD2531 Manual De Instrucciones

10. Refit the bottom bracket and hinge pin.
Replace both adjustable feet.
11. Lift the door back on. Ensure the door is
aligned horizontally and vertically, so that
the seals close on all sides before finally
tightening the top hinge.
12. Replace the top cover and fix it with 2
screws on the back. Install the external door
handle (if present)
Installing the external door handle
(if present)
Screw
Space Requirement
Allow for enough space for the
door to open.
Ensure at least a 50 mm gap on
both sides.
Rear spacers
Screw the rear spacers to the rear
of the unit
10
refrigerator single door
Levelling the unit
To do this, adjust the two leveling feet at front
of the unit.
If the unit is not level, the doors and magnetic
seals will not be properly aligned.
Positioning
Install this appliance in a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the
appliance:
Climate class
SN
N
ST
T
Location
The appliance should be installed well away from sources of heat
such as radiators, boilers, direct sunlight, etc. Ensure that air can
circulate freely around the back of the cabinet. To ensure best
performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm. Ideally, however, the appliance
should not be positioned below overhanging wall units. Accurate
leveling is ensured by adjusting one or more of the adjustable feet at
the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the
mains power supply; the plug must therefore be easily accessible
after installation.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown
on the rating plate correspond to your domestic power supply. The
appliance must be earthed. The power supply cable plug is provided
with a contact for this purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate earth, in compliance
with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety
precautions are not observed. This appliance complies with the EU
Directives.
EN
KSD2531
Ambient temperature
+10º C to +32º C
+16º C to +32º C
+16º C to +38º C
+16º C to +43º C
11