Maintenance; Defrosting The Freezer; Replacing The Lamp - Kunft KSD2531 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• do not open the door frequently or leave it open longer than
absolutely necessary.
• Once defrosted, food deteriorates rapidly and cannot be refrozen.
• Do not exceed the storage period indicated by the food manufacturer.
Hints for fresh food refrigeration
To obtain the best results:
• Do not place warm food or steaming liquids in the refrigerator
• Cover or wrap food, particularly if it has a strong flavor
• Meat (all types): wrap in polythene bags and place on the glass
shelves above the vegetable drawer.
• For safety, store like this for only one or two days at the most.
• Cooked foods, cold dishes, etc...: these should be covered and may
be placed on any shelf.
• Fruit and vegetables: these should be thoroughly cleaned and
placed in the special drawer(s) provided.
• Butter and cheese: these should be placed in special airtight
containers or wrapped in aluminum foil or polythene bags to
exclude as much air as possible.
• Milk bottles: these should have a cap and should be stored in the
shelves on the door.
• Bananas, potatoes, onions and garlic must not be kept in the fridge
unless packaged.
Energy saving
• Don't put hot food in the appliance;
• Don't pack food items close together as this prevents air circulating;
• Make sure food does not touch the back of the compartment(s);
• If the electricity goes off, don't open the door(s);
• Don't open the door(s) frequently;
• Don't keep the door(s) open for too long;
• Don't set the thermostat to exceedingly cold temperatures;
• Some accessories, such as drawers, can be removed to get larger
storage volume and lower energy consumption.

2.3. Maintenance

For hygienic reasons, the appliance's interior, including interior
accessories, should be cleaned regularly.
Caution! The appliance must not be connected to the mains during
cleaning. Danger of electrical shock! Before cleaning, switch the
appliance off and unplug from the mains, or switch off the circuit
breaker, or remove the fuse. Never clean the appliance with a steam
cleaner. Moisture may accumulate in electrical components resulting
in danger of electrical shock! Hot vapor can cause damage to plastic
parts. The appliance must be dry before it is put back into service.
14
refrigerator single door
Important! Ethereal oils and organic solvents can attack plastic
parts, e.g. lemon juice or the juice from orange peel, butyric acid, or
cleansers that contain acetic acid.
Cleaning the drain hole
To avoid defrost water overflowing into the
fridge, periodically clean the drain hole at back
of fridge compartment. Use a cleaner to clean
the hole as shown in the picture on the right.
• Do not allow such substances to come into contact with appliance
parts.
• Do not use any abrasive cleaners.
• Remove any food from the freezer. Store in a cool place and keep
well covered.
• Switch the appliance off and unplug from the mains, or switch off the
circuit breaker, or remove the fuse.
• Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning, wipe with fresh water and wipe dry.
• After everything is dry, the appliance can be put back into service.

Defrosting the freezer

The freezer compartment, however, will become progressively
covered with frost. This should be removed. Never use sharp metal
tools to scrape off frost from the evaporator as you could damage it.
However, when the ice becomes very thick on the inner liner,
complete defrosting should be carried out as follows:
• unplug the power cord from the socket;
• remove all stored food, wrap it in several layers of newspaper and
put it in a cool place;
• keep the door open, and place a basin underneath the appliance to
collect the melted ice;
• when defrosting is completed, dry the interior thoroughly;
• replace the plug in the power socket to run the appliance again.

Replacing the lamp

Caution! Before replacing the lamp, the appliance must be
disconnected from the mains power supply.
The lamp specification is listed in the rating label. Follow the process
below to replace the lamp:
1. Set the temperature regulator knob to number "0" to switch off the
appliance.
2. Unplug the appliance to make sure the
appliance is disconnected from the main
power supply.
3. Remove the lamp cover screw.
EN
KSD2531
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido