Residual Risks; Electrical Safety - Black and Decker GW3031BP Manual Del Usuario

Electrical safety

Using an extension cable
persons with reduced physical, sen-
sory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children shall not play with
the appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Children should be supervised to
ensure that they do not play with the
appliance.
This appliance is double insu-
lated; therefore no earth wire is
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
by using a highsensitivity 30 mA Re-
sidual Current Device (RCD).
Always use an approved extension
cable suitable for the power input of this
tool (see technical data). The extension
cable must be suitable for outdoor use
and marked accordingly. Up to 30 m of
1.5 mm² HO5V V-F extension cable can
be used without loss of product perfor-
mance. Before use, inspect the extension
cable for signs of damage, wear and age-
ing. Replace the extension cable if dam-
aged or defective. When using a cable
reel, always unwind the cable completely.
u
required. Always check that the
u
u

Residual risks

Vibration
When using the tool which may not be
included in the enclosed safety warnings.
These risks can arise from misuse, pro-
longed use etc. Even with the application
of the relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
Injuries caused by touching any
rotating/moving parts.
Injuries caused when changing any
parts, blades or accessories.
Injuries caused by prolonged use of
a tool. When using any tool for pro-
longed periods ensure you take
regular breaks.
Impairment of hearing.
Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.).
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN50636 and
may be used for comparing one tool with
another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value
during actual use of the power tool can
differ from the declared value depending
on the ways in which the tool is used.
The vibration level may increase above
the level stated.
When assessing vibration exposure to
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
(Original instructions)
u
u
u
u
u
determine safety measures required by
ENGLISH
7