Bosch PCM 10 Manual Original página 43

OBJ_BUCH-573-001.book Page 43 Thursday, November 29, 2007 9:23 AM
Maximum Workpiece Dimensions
Mitre/Bevel Angle
Horizon- Vertical
tal
90° 90° 80 x 125
45° 90°
90° 45° 45 x 125
Cutting Off
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Adjust the requested horizontal and/or verti-
cal mitre/bevel angle.
– Switch on the machine.
– Press button 1 and guide the tool arm slowly
downward with handle 2.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length
(see figure R)
The length stop 38 can be used for easily sawing
workpieces to the same length.
– Loosen wing nut 56 and position the length
stop to the requested distance to the saw
blade.
– Tighten the wing nut again.
– Position the workpiece against the stop.
Check again with the cutting line marked by
the laser if the length stop is positioned cor-
rectly.
– Now saw this and the additional workpieces
to the same length in accordance with the
work steps in Section "Cutting Off".
Bosch Power Tools
Special Workpieces
When sawing curved or round workpieces,
Height x Width
these must be especially secured against slip-
[mm]
ping. At the cutting line, no gap may exist be-
at max. at max. tween workpiece, fence and saw table.
height width
Provide for special fixtures, if required.
60 x 140
Replacing the Insert Plate
80 x 90 60 x 100
45 x 140
The red insert plate 9 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
– Unscrew the screws 57 using the provided
– Insert the new insert plate and and screw all
Sawing Profile Strips/Mouldings (Floor
and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
(see figure S)
tion.
Phillips screwdriver and remove the old in-
sert plate.
screws 57 in again.
1 609 929 J60 | (29/11/07)
English | 43