Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-573-001.book Page 44 Thursday, November 29, 2007 9:23 AM
44 | English
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Horizontal mitre
Outer
angle
corner
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Checking and Adjusting the Basic Adjustment
¢ Before any work on the machine itself, pull
the mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Adjusting the Laser
– Bring the power tool into the working posi-
tion.
– Turn the saw table 14 until it engages at 0°.
– Remove the cover 58. (see figure T1)
1 609 929 J60 | (29/11/07)
Placed
against
the fence
0°
Left side
Right side
45° left
45° right
Bottom edge
Bottom edge
on saw table
on saw table
... to the left of
... to the right
the cut
of the cut
45° right
45° left
Bottom edge
Bottom edge
on saw table
on saw table
... to the right
... to the left of
of the cut
the cut
Checking: (see figure T2)
– Draw a straight cutting line on the work-
piece.
– Press button 1 and guide the tool arm slowly
downward with handle 2.
– Align the workpiece in such a manner that
the teeth of the saw blade are in alignment
with the cutting line.
– Hold the workpiece in this position and slow-
ly guide the tool arm upward again.
– Clamp the workpiece.
– Switch the laser beam on with switch 33.
The laser beam must be in alignment with the
cutting line on the workpiece over the complete
length, also when the tool arm is lowered.
Lying flat
on the
saw table
45°
Left side
Right side
0°
0°
Upper edge
Bottom edge
against the
against the
fence
fence
... to the left of
... to the left of
the cut
the cut
0°
0°
Bottom edge
Upper edge
against the
against the
fence
fence
... to the right
... to the right
of the cut
of the cut
Bosch Power Tools
Publicidad
Tabla de contenido
