Machine-Specific Safety Warnings; English | 33 - Bosch PCM 10 Manual Original

OBJ_BUCH-573-001.book Page 33 Thursday, November 29, 2007 9:23 AM
g) If devices are provided for the connec-
tion of dust extraction and collection fa-
cilities, ensure these are connected and
properly used. Use of dust collection can
reduce dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better
and safer at the rate for which it was de-
signed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be re-
paired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfa-
miliar with the power tool or these in-
structions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp
cutting edges are less likely to bind and
are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these in-
structions, taking into account the work-
ing conditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Bosch Power Tools
5) Service
a) Have your power tool serviced by a qual-
ified repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
Machine-specific
Safety Warnings
¢ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
¢ Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
¢ Never leave the machine before it has come
to a complete stop. Cutting tools that are
still running can cause injuries.
¢ Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
¢ Never make warning signs on the machine
unrecognisable.
¢ Never stand on the power tool. Serious inju-
ries can occur when the power tool tips over
or when inadvertently coming into contact
with the saw blade.
¢ Make sure that the guard operates properly
and that it can move freely. Never lock the
guard in place when opened.
¢ Keep hands away from the cutting area
while the machine is running. Danger of in-
jury when coming in contact with the saw
blade.
¢ Never remove cutting remainders, wood
chips, etc. from the sawing area while the
machine is running. Always guide the tool
arm back to the neutral position first and
then switch the machine off.
1 609 929 J60 | (29/11/07)

English | 33