Start Sewing; Finish Sewing; Guide Bar - Texi Tegra 4 Manual De Instrucciones

START SEWING

FINISH SEWING

1.
When approaching the edge of the fabric, hold the threads, pull them backwards and sew
slowly. Note: Make test firts on piece of material, before you start to sew.
2. Finishing coverstitch
Sew 4-5 stitches on top of each other. During the last stitch, turn the handwheel toward
you until the needles stick into the fabric and you hear click sound (just before reaching the
lowest position).
After second clicks, turn the handwheel in the opposite direction until the needle reaches
the top. Raise presser foot. Cut the thread, the needle threads are pulling back and knotted,
the fabric can lock the back end of the threads. Remove fabric.

GUIDE BAR

Texi Tegra 4 INSTRUKCJA 2019.indb 93 Texi Tegra 4 INSTRUKCJA 2019.indb 93
Raise the presser foot, and then place the fabric under
it on the plate depending on the width of the stitch.
When you start sewing, pull the fabric slightly back and
start sewing at a slow speed.
Remove the guide bar from the accessory
box, put it in the A, through the left and
right mobile guide bar, adjusted to the
desired location.
In the sewing cover stitch and 2-thread
chain stitch, guide bar for regular interval
overcast stitch is very useful.
Texi Tegra 4
EN
93
18.09.2020 09:42 18.09.2020 09:42