Magnet; Swivelling The Battery-Powered Led Work Light; Snap Fastening; Tripod Mount - Parkside PLLA 12-Li A1 Traducción Del Manual De Instrucciones Original

G B I E

Magnet

Take care, because
sliding the batte-
ry-powered LED work
light can cause the
magnetic surface to
become scratched!
Using the magnets (13),
you can fix the battery-po-
wered LED work lamp to
magnetic surfaces
The appliance housing
(3) with LED lamp can be
installed on the base (5) in
8 positions
Swivelling the
battery-powered
LED work light
The appliance housing
(3) with LED lamp can be
installed on the base (5) in
8 positions.
If you put the battery-po-
wered LED work light on a
non-magnetic surface, make
sure that it is in a stable
position. The 90º angle
shown in illustration
must not be exceeded.
2 8

Snap fastening

You can secure the batte-
ry-powered LED work light
using the snap fastening
(6) on the base (5). For
example, onto a belt loop,
a rope or similar

Tripod mount

Using the 1/4" inner thread
(14) you can screw the
battery-powered LED work
lamp onto a tripod (not
included in this package).

Maintenance

The battery-powered LED
work lamp is maintenance-
free

Cleaning

Before cleaning, dis-
connect the charger
from the mains
and switch off the
battery-powered LED
lamp.
• Clean the battery-powe-
red LED work lamp with
a soft, dry cloth to avoid
scratching the cover of
the LED lamp.
• Clean the charger and
the battery with a dry
cloth or with a paint