Pause Length; Length Of Busy Redial; Troubleshooting Guide - Panacom PA-7300M Manual Del Usuario

time can be adjusted between 0.1 and 0.9 second (increasing 0.1
seconds each time):
1. Press STORE.
2. Press a number key between 1 and 9 to set a flash signal length
between 0.1 and 0.9 seconds.
3. Press STORE again.
4. Press FLASH.

Pause Length

ADJUSTING THE LENGTH OF THE PAUSE FUNCTION
This telephone allows you to change the Pause function to suit a
special telephone situation. Normal Pause operation is a wait of 4
seconds before continuing a dial sequence. The length can be ad-
justed between 1 and 9 seconds (increasing 1 second each time):
1. Press STORE.
2. Press a number key between 1 and 9 to select a pause duration
between 1 second and 9 seconds.
3. Press STORE again.
4. Press PAUSE.
TIP: It might be necessary to try different option of the length Pause
to obtain the specific time to get access to a particular service,
therefore it could be simpler to use the Chain dial and hold for each
access tone before pressing the next memory location button.

Length of Busy Redial.

You can change the length of each redial when using the Busy redial
function between 0 and 90 seconds (increasing 10 seconds each time).
1. Press STORE.
2. Press the key of the number to select the amount of seconds (1 to
9 represents 10 to 90 seconds).
3. Press STORE and then press BUSY REDIAL button.

TROUBLESHOOTING GUIDE

Problem: No dial tone when you pick up handset
Solution: You must press a line button to get a dial tone
Problem: No dial tone when you press a line button
Solution: Check hook switch. Does it pop up when handset is picked up?
Make sure phone line cord is connected
Pg. 15