Automatic Cooking; Pause Function; Recall Function; Keep Warm » Function - Foster S4000 Manual De Instrucciones

Automatic cooking

All the cooking zones are equipped with an automatic "go and stop" cooking device. The cooking
zone starts at full power during a certain time, then reduces automatically its power on the pre-
selected level.

Start-up :
Action
Zone selection
Full power setting
Automatic cooking
Power level selection
(for example « 7 »)

Switching off the automatic cooking :
Action
Zone selection
Power level selection

Pause function

This function brakes all the hob's cooking activity and allows restarting with the same settings.

Startup/stop the pause function :
Action
Engage pause
Stop the pause

Recall Function

After switching off the hob [ 0/I ], it is possible to recall the last settings.
 cooking stages of all cooking zones (power)
 minutes and seconds of programmed cooking zone-related timers
 Heat up function
The recall procedure is following:
 Press the key [ 0/I ]
 Then press the key [ II ] within 6 seconds
The precedent settings are activated.
« Keep warm » Function
This function allows to reach and maintain automatically a temperature of 70°C.
This will avoid liquids overflowing and fast burning at the bottom of the pan.

To engage, to start the function « Keep warm » :
Action
Zone selection
To engage
To stop
This function can be started independently on all the heating zones.
When the pan leaves the cooking zone of the "Keep warm" function remains active during
approximately 10 minutes.
The maximum duration of keeping warm is 2 hours.
Control panel
press display [ 0 ] selected
slide on the "SLIDER" to [ 9 ]
re-press on display "SLIDER" [ 9 ]
slide on the "SLIDER" to [ 7 ]
Control panel
press [ 7 ] from the zone
slide on the "SLIDER"
Control panel
press [ II ] key during 2s
press [ II ] key during 2s
press an other touch or
slide on the "SLIDER"
Control panel
press display [ 0 ] selected
press on key [ U ] on the "SLIDER"
press on display [ U ] selected
slide on the "SLIDER"
Display
[ 0 ] and control light on
pass from [ 0 ] to [ 9 ]
[ 9 ] is blinking with [ A ]
[ 9 ] pass to [ 8 ] [ 7 ]
[ 7 ] is blinking with [ A ]
Display
[ 7 ] blinking with [ A ]
[ 1 ] to [ 9 ]
Display
displays [ II ] in the
heating zone displays
pause control light is blinking
pause control light is off
Display
[ 0 ] to [ 9 ] or [ H ]
[ U ]
[ U ]
[ 0 ] to [ 9 ] or [ H ]
29