Mopar 82212110 Instrucciones De Montaje página 20

20
87. If equipped, connect the cargo lamp (2) electrical con­
nector.
88. Position the trim (3) into place inserting the outer clips
first then the inner ones.
89. Seat the retaining clips fully.
UPDATE VEHICLE CONFIGURATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
1. VIN must be updated with the sales code of the added accessory in order to enable system functionality. Using the
DealerCONNECT website and the wiTECH diagnostic application, complete the vehicle configuration.
2. Log on to https://dealerconnect.chrysler.com.
3. In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN, four digit pin number obtained from the dealership parts department and add sales code(s) noted below as a
"Dealer Installed Option".
XAC (Park View Rear Back­Up Camera)
4. Confirm that the new sales code has been successfully added to the VIN.
5. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note On­Screen instructions and select the "Close" button
Jun 16, 2010 K6860985 ver. 1