Tristar TR-2547 Manual De Instrucciones página 21

firmly to the bottom of the clipper blade,
Attachment comb #1 --- leaves hair approx. Blending in length
Attachment comb #2 --- leaves hair approx. 1/4" in length
Attachment comb #3 --- leaves hair approx. 1/2" in length
Attachment comb #4 --- leaves hair approx. 3/4" in length
Special angle comb is available.
● At the beginning, cut only a small amount of hair until you become
accustomed to the length each attachment comb leaves the hair.
● It is suggested to try the longest attachment comb on the clipper
first, then use the shorter one if the desired length is shorter.
● For uniform cutting, never push or force the clipper through
the hair at a fast rate. The clipper works most efficiently
when it works at its own speed.
● Start by combing the hair in its natural direction,
● Place the largest, attachment comb onto your clipper and
start by trimming the sides from the bottom upwards.
Hold the clipper lightly against the hair with teeth of the
attachment comb pointing up but flat against the head.
Slowly lift the clipper up and outward through the hair,
cutting only a small amount at a time.(Fig. 1)
● Repeat around sides and back of head.(Fig.2)
●
If you desire shorter hair, either change to a lower
number attachment comb or apply more pressure and
less lift away from head with the present attachment
comb.
●
This entire procedure requires practice, and it is always
better to leave too much hair the first few haircuts.(Fig.3)
●
For the top of the head, you will give a fairly short cut if
21
Fig.1
Fig.2
Fig.3
Fig.4