Tristar TR-2547 Manual De Instrucciones página 23

If a short tapered cut on the sides and back is desired, follow the diagram below:
The four basic areas illustrated on the hair cutting guide are your "road map" to easy do-it-
yourself hair cutting.
MAINTENANCE
● Your clippers were carefully examined to ensure that the blades were
oiled and aligned before leaving our factory.
● Blades must be realigned if they have been removed for cleaning or
replacement.
To realign the blades, simply match the upper and bottom blades teeth
up, point for point.
(End of top blade teeth)
should be approximately
1.2mm back from bottom blade.
Compare your clipper blades
with the sketch)
● If blade alignment is incorrect, add a few
drops of oil to the blades, turn clipper on for a
few moments, turn off and unplug. Loosen
screws slightly and adjust. Tighten screws
after blade is aligned.
Oil
● To maintain your clipper in peak condition,
the blades should be oiled every few
haircuts.
● Do not use hair oil, grease, oil mixed with
kerosene or any solvent. As the solvent will
evaporate and leave the thick oil which may
slow down the blades motion.
Adjustable lever
● The lever is conveniently located near your thumb (if you're right-
handed) so it can easily be adjusted while the clipper is in your hand.
● The lever adds versatility to your clipper by allowing you to gradually
change the closeness of your cut without an attachment comb.
23