Industry Canada Notice - Plantronics A20 Guía Para El Usuario

•a20APLABody3 12/16/01 8:58 PM
SUPPLIES AND ACCESSORIES
Auto Lifter (P/N 60961-01)
Reduces the steps necessary to answer a call by
automatically placing the handset off-hook when the
Handset/Headset is pressed.
OLI Extension Cord (P/N 46429-01)
Allows placement of OLI further from amplifier.
Lightweight Amplifier to QD Cord (P/N 40702-01)
Reduces headset weight and desk clutter.
Lightweight Extension Cord (P/N 40711-01)
Increase mobility in your work area; let's you stay on the line
while moving away from the amplifier.
INFORMATION ON SUPPLIES AND ACCESSORIES
Contact your local distributor or visit our website at
www.plantronics.com. See also Diagram Key for additional part
numbers.
Page 14
14

INDUSTRY CANADA NOTICE

This Class B digital apparatus complies with Canada ICES003.
Notice: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective,
operational and safety requirements. The Department does not guarantee the
equipment will operate to the users satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company's inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made
by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect
the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic water pipe
system, if present, are connected together. This precaution may be particularly
important in rural areas.
Caution: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device
provides and indication of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on an interface may consist
of any combination of devices subject only to the requirement that the sum of the
Ringer Equivalence Numbers of all devices does not exceed 5.
See label on unit for REN No., as applicable.
15