Declaration Of Conformity; Fcc Class B Compliance Statement - Siemens FUJITSU COMPUTERS SCENIC S Manual De Manejo

Indicaciones del fabricante

Declaration of Conformity

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Product Name:
Trade Name:
Model Number:
Name of Responsible Party:
Contact Person:
Phone No.:
Fax No.:
We, Fujitsu Siemens Computers Inc., hereby declare that the equipment bearing the trade name
and model number specified above was tested conforming to the applicable FCC rules under the
most accurate measurement standards possible, and that all the necessary steps have been taken
and are in force to assure that production units of the same equipment will continue to comply with
the Commissions requirements.

FCC Class B Compliance Statement

The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-
Causing Equipment Regulations. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in strict accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between equipment and the receiver.
·
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
·
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Siemens Computers GmbH is not responsible for any radio or television interference caused
by unauthorized modifications of this equipment or the substitution or attachment of connecting
cables and equipment other than those specified by Fujitsu Siemens Computers GmbH The
A26361-K523-Z100-6-7819
Personal Computer
Devicename+Systemboard
Name+Systemboard
Fujitsu Siemens Computers Inc.
598 Gibraltar Dr.
Milpitas, CA 95035-6315
U.S.A.
Mike Fitzner
(408) 571-6036
(408) 571-6191
Indicaciones importantes
5