MasterCool MCP44-PAD Instrucciones Para El Reemplazo

INSTRUCTIONS FOR REPLACEMENT OF COOLER PADS
OPEN UNIT UP
1.
C
. Pull back of unit away
3. INSTALL NEW BACK PAD
Position large pad inside the back grill.
(Location of 5 pegs
for back pad.)
P/N 72618 11-2013
A
Remove 4 screws
.
from back of unit
B.
Push up on back of unit.
Install new pad by pushing pegs
over rib in back grill and through
media pad, then pushing a
clip onto each peg.
Peg
2.
4. INSTALL NEW SIDE PADS
Clip
REMOVE OLD PADS
Locate media pegs and remove.
Using pliers,
pull plugs out
from the exterior.
Or pull
clips off
pegs from
the interior.
NOTE: New plugs and clips are included
in replacement kit. Dispose of used pads,
plugs and clips.
Position small sections of the pad in the
sides of the back grill.
Install each
side pad
using 2 pegs
and clips.
Locate pegs at
top and bottom
for best support.