Installation Instructions; Initial Setup - GE GXFM07HWW Instrucciones De Instalación

INITIAL SET-UP
Wash hands.
1
2 Remove the cap of the filtration system by
inserting a small coin or screwdriver on the back
of the system and pry to remove cap.
3 Remove the packaging and label at the bottom
of the new filter. Then install the new filter. Be
sure to support the filter housing in your hand
and press the new filter into the housing firmly.
Then turn the filter clockwise until hand-tight.
Continue to turn until the tab lines up with
the non-filtered icon as shown below:
Take the cap and turn it over. Use a small coin
4
or screwdriver to rotate the battery cover
counterclockwise. Turn the cap right-side-up
and the battery cover will drop out.

Installation Instructions

Insert a small coin
or screwdriver
on the back and
pry to remove cap.
Twist filter
clockwise
to install.
Tab on filter
will line up
with the
Non-filtered
icon when the
filter is fully
installed.
Insert a small coin or
screwdriver and turn
counterclockwise to
open.
2
INITIAL SET-UP (CONT.)
Insert the new battery "+" side up.
5
Black tabs
6 Replace the battery cover. Use the alignment
arrows to ensure you have the cap in the proper
position. Using a small coin or screwdriver, turn
clockwise to lock in place.
7 Using a ballpoint pen, push the RESET button.
The left green light on the cap will flash 5 times.
If the light does not flash, reinstall the battery.
Be sure the "+" side is up as shown in Step 5.
Insert a
small coin or
screwdriver
and turn
clockwise
to lock in
place.
Align the cap with the filter housing (lights in the
8
front) and press it down into place.
NOTE: The cap is designed to fit on the filter housing
only one way.
Press RESET
button with a
ballpoint pen
after filter
and battery
replacement.