Guarantee & Service - Philips GC6107 Manual Del Usuario

Problem
Some smoke comes
out of the appliance
after it has been
switched on for the
first time.
Dirt particles come
out of the soleplate
of the new iron.
Droplets of water
escape from the
soleplate.
The appliance does
not produce any
steam.
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care Centre
in your country (you find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your country, go to your
local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.
troubleshooting
This chapter summarises the most common problems you could encounter
with your iron. Please read the different sections for more details. If you
are unable to solve the problem, please contact the Philips Customer Care
Centre in your country (you will find its phone number in the worldwide
guarantee leaflet). If there is no Customer Care Centre in your country,
turn to your local Philips dealer or the nearest Philips service centre.
Cause
This is normal. Some parts of the iron
have been greased lightly in the factory.
This is normal with a new iron.
The temperature dial has been set to a
temperature that is too low for steam
ironing.
The iron is not switched on.
The steam tank has been placed on an
unstable and/or uneven surface.
When you start steam ironing, the
hose is cold. Steam condenses in the
hose, causing droplets of water to
escape from the soleplate.
The steam tank and/or the iron has/
have not been switched on.
The steam tank is not hot enough to
produce steam.
Solution
This phenomenon will cease after a
short while.
These particles are harmless and they
will stop coming out of the soleplate
when you have used the iron a few
times.
Select an ironing temperature that is
suitable for steam ironing (temperature
settings 2 to MAX).
Set the iron switch to 'on' and wait until
the iron is hot.
Put the steam tank on a stable and even
surface.
This is normal. Hold the iron over an
old cloth and press the steam activator.
The cloth will absorb the drops. After a
few seconds the steam production will
have normalised.
Set both the iron switch and the steam
tank switch to 'on'.
Wait 6 to 8 minutes for the steam tank
to heat up.
EnGlish
1