Fast Refill; Setting The Temperature - Philips GC6107 Manual Del Usuario

EnGlish
8
 Slowly unscrew the cap of the steam tank.
You may hear a sound when you remove the cap. This sound is caused by
the vacuum or residual pressure inside the steam tank and is perfectly
normal.
 Pour water into the steam tank (max. 1 litre).
Use tap water to fill the tank.
If the tap water in your area is very hard, we advise you to use 50%
,
distilled water and 50% tap water.
Do not put perfume, vinegar, starch, descaling agents, ironing aids or
other chemicals in the steam tank.
 Screw the cap tightly onto the filling aperture of the steam tank.

Fast refill

1 Keep the appliance plugged into the mains and make sure the iron is
on. Then set the steam tank switch to 'off'.
 Press the steam activator until you no longer hear any steam
escaping from the appliance.
 Keep the steam activator pressed in and slowly unscrew the cap of
the steam tank by turning it anticlockwise. This will depressurise the
steam tank.
Make sure there is no steam left in the steam tank. Place a piece of cloth
over the cap when unscrewing it.
 Remove the mains plug from the wall socket.
5 Fill the steam tank as described in section 'Filling the steam tank' and
let the appliance heat up again.

setting the temperature

Always place the steam tank on a stable, level and horizontal surface. Do
not put the steam tank on the soft part of the ironing board.
1 Put the iron on the iron stand.
Do not put the hot iron on the supply hose or the mains cord. Make
sure the cord does not come into contact with the hot soleplate.