Care And Cleaning - Sinbo SK 7321 Instrucción Del Uso

Cleaning
1. Switch the kettle off (lift it from the power base), unplug the power base from the wall socket and
let the kettle cool down completely before cleaning.
2. Wash the outside and inside surfaces of the kettle with a damp cloth. If necessary, you may use a
little household detergent. To clean the filter, see "Water filter" below. If you use detergent inside the
kettle, rinse thoroughly afterwards to remove all trace if the detergent.
3. Ensure that all connectors and sockets are kept dry.
Do not immerse the kettle or power base in water or any other liquid.
Do not use harsh or abrasive cleaners or solvents.
It should not be cleaned into water or it can not be cleaned by the dishwasher.
Descaling
Scale build-up will cause the element to overheat, reducing its working life. It may also cause the safety
cut out to operate prematurely, switching the kettle off before the water boils
As the element is mounted beneath the kettle, there are no awkward nooks and crannies for the scale
to get a foothold. It can build up only on the walls and floor of the kettle, where it can be seen and dealt
with.
To minimize scale build-up:
1. Empty the kettle after each use; do not allow water to stand in the kettle overnight; use filtered water
instead of ordinary tap water.
2. Descale the kettle regularly using a proprietary brand of descaler suitable for use in plastic-bodied
products. In areas of very hard water descaling may be necessary as often as once a month.
3. When decaling, follow the instructions on the packet of descaler. When descaling has finished, empty
the kettle and rinse it out several times with fresh water, then fill with fresh water, boil. And discard
the water. This should ensure the no chemical residues are left in the kettle.
Please note: Products returned during the guarantee period with faults that are directly related to
scale built-up will be subject to a repair charge.
Water filter
The scale particles that remain suspended in the water may give it a cloudy or greasy appearance,
depending on the hardness of the water.
The filter fitted to your kettle will prevent these parties passing into your drink. You must ensure that
the filter is kept clean and clear of deposits otherwise the performance of your kettle may be adversely
affected, your drinks may contain scale particles, and the water inside the kettle may look cloudy.
You should clean the filter whenever there are any noticeable deposits left on it, and especially if pouring
is affected in any way.
SPECIFICATIONS
Rated voltage : AC230V, 50Hz
Power : 2000W
Capacity : 1.7L
This appliance is to be stored and used under the following conditions: temperature-not less than +5˚C
relative humidity-not greater than 80%;aggressive impurities in the air: not allowable.
As the manufacturer is constantly working on improvement of its products, the design and technical
specifications are subject to change without prior notice.

CARE AND CLEANING

- 9 -