Troubleshooting - Lanaform TENSIOS1 Manual Del Usuario

APPLIED STANDARDS
This product conforms to the previsions of the EC directive MDD (93/42/EEC).
The following standards apply to design and/or manufacture of the products:
- EN 1060-1
Non-invasive sphygmomanometers – Part 1 : General requirements
- EN 1060-3
Non-invasive sphygmomanometers – Part 3 : Supplementary requirements for
electro-mechanical blood pressure measuring system
- ANSI/AAMI SP10
Electronic or automated sphygmomanometers
- IEC/EN 60601-1
Medical electrical equipment – Part 1 : General requirement for safety
- IEC/EN 60601-1-2
Medical electrical equipment – Part 2 : Collateral standard: Electromagnetic
compatibility – Requirements and tests

TROUBLESHOOTING

Condition
No display after push the
Start / Stop button
Replace batteries symbol
Utilization times become
less
No reading after
measurement
Cause
The positions of the
batteries are incorrect.
The voltage of the batteries
is extremely low.
The voltage of the batteries
is extremely low.
When chilly, the batteries
might have a weak electron
release.
Might not utilize the Alkaline
batteries.
The voltage of the batteries
is extremely low.
• 31 •
Corrective Action
Insert the batteries in the
correct positions.
Replace all four batteries
with new ones.
Replace all four batteries
with new ones.
Warm up the batteries, or
place at a warm place for a
while then re-start again
Try to utilize the Alkaline
batteries.
Replace all four batteries
with new ones.