Gaggenau 200 Serie Instrucciones De Montaje página 5

en
Connection
The appliance is supplied with a itted plug and may only
be connected to a correctly installed earthed socket. Only
an electrician may it a socket or replace the power cord, in
compliance with the relevant regulations.
If the plug is no longer accessible following installation of
the appliance, there must be an all-pole disconnector with
a contact gap of at least 3 mm on the installation side.
Only an appliance which has been correctly installed
according to these installation instructions can be used
safely.
Attach loose furniture to the wall with a conventional
bracket.
Included in delivery – Fig. 1
a Chassis (with telescopic slides)
b Support plate with appliance and front panel
c Wood screws (4x)
d Self-tapping screws (2x)
Installing the appliance – Fig. 2-4
The minimum spacing between wall and built-in housing of
200 mm must be maintained.
Make sure there is adequate aeration. To do this, remove
the rear panel or cut out an opening of 500 x 400 mm.
There must be a gap of at least 45 mm between the wall
and base of the unit or the rear panel of the unit situated
above.
The ventilation slots and intake openings must not be
covered.
Also follow the installation instructions for the appliance
situated above or below.
If installing the appliance above a warming drawer, the
height of the recess must be 590 mm.
If the appliance is installed directly under a décor panel,
ensure that there is a ventilation slot of at least 200 cm².
The ideal installation height for the fully automatic
espresso machine, measured from the loor to the lower
edge of the appliance, is 95 cm.
•
First unpack all parts according to the instructions
and check for damage in transit.
Do not switch on a damaged appliance.
•
Then attach the chassis
front, with the enclosed 4 screws
•
Remove the adhesive strip to activate the mainspring.
•
Plug the power cord into the socket.
Do not trap or kink the power cord.
Important: The appliance must be placed on the tele-
scopic slides only when they are fully extended, so that the
deployment mechanism is activated when it is pushed in.
1 Pull out the two telescopic slides
2 Place the support plate b
two telescopic slides. Secure with the two screws d.
3 Plug the helix cable of the appliance into the chassis,
being careful not to overstretch it.
If the appliance protrudes or does not engage after
4
being pushed in, this can be adjusted.
•
If the appliance protrudes:
Insert Allen key SW3 and turn it to the left
•
If the appliance does not engage:
Insert Allen key SW3 and turn it to the right
Finally, check that the electrical and manual deployment
mechanism works correctly.
a , centred and lush at the
c .
fully .
with the appliance on the
X .
Y .
3