Led Lighting; Installing The Filter - CIANO nexus Pure 15 C Guía De Uso

Uk
RECOMMENDATIONS
Before installing and using
the various bits of electrical
equipment, read all the
following safety notices and
instructions carefully.
1 • Carefully remove the
components from the packa-
ging. Place the neXus pure®
on a solid stable surface.
2 • The neXus pure® requires
an electrical outlet. Do not
place the neXus pure® above
electrical appliances.
3 • Position the tank in the
centre of the base. Allow 1 cm
between the tank and the
(figure 10)
columns.
4 • Make a "drip curve"
(figure 10/B)
to prevent water
from coming into contact with
the electrical power source.
Congratulations on your new neXus pure®.
We wish you success and many years of pleasurable fish keeping!
5 • Do not place the neXus
pure® near heat sources or in
direct sunlight.
6 • Maximum Water Level.
(figure 10/A)
7 • Do not move the neXus
pure® while it is full.

LED LIGHTING

Lighting system setup.
1 • Disconnect the switch.
(figure 1)
2 • Connect the converter to
the lighting system.
(figure 1)
3 • Connect the converter to
(figure 2)
the power source.
4 • Connect the switch.
(figure 2)
Replacing the lighting
system.
1 • Remove the glass tank
and take off the support
(figure 3)
plate.
2 • Remove lids A and B.
(figure 4)
3 • Loosen the light fitting.
(figure 5/C)
4 • Reverse the procedure
above to fit the new light.
(figure 6)

INSTALLING THE FILTER

The filtering system inclu-
ded guarantees the best
renewal of water and
excellent maintenance of
aquatic balance.
1 • Use the spray bar
(figure
or the regulator
2 • Remove lid (figure
insert the filter; pass the
electric wire through the
column and then replace the
lid.
4
Maintenance:
lubricated by water, it is there-
fore essential never to operate
with a dry filter, this would
cause the rotor to wear rapidly.
(figure 10)
MAINTENANCE
1 • It is advised that mainte-
nance of the filter is carried
out periodically because of
the compression of the
filtering mass which must be
cleaned or replaced. The filter
must be cleaned using a
brush to remove all dirt.
(figure 11 and 12)
(figure 7)
8).
Environment protection!
9/B);
Your appliance
materials which can be recovered or
recycled. Take it to your local waste
collection centre.
the rotor is
contains valuable