Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific RMS300 Manual De Usuario

1. MODE: Toggle between clock displays; enter setting
mode
2. : Increase values in setting mode; activate clock
signal reception
3. RESET: Reset unit to default settings
4. USB port (at the side)
5. Battery compartment (at the bottom)
6. MEM:Toggle between
temperature / humidity displays
7. : Decrease values in setting mode; deactivate
clock signal reception
8. °C / °F: Select temperature unit
9. EU / UK: Select the nearest radio signal (RMS300
only)
REMOTE SENSOR (FIG 3)
1
maximum and minimum
2
4
3
5
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG
2).
3. Press RESET after each battery change.
LOCATION
Clock / alarm area
Outdoor temperature area

REMOTE SENSOR

The remote sensor can collect data from up to 3 channels.
To set up the remote sensor:
1. Open the battery compartment and insert batteries,
matching the polarity.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the remote sensor within 30 m (98 ft) from the
main unit.
3
MEANING
Main unit batteries low
Remote sensor batteries low