Product Features - HoMedics FS-505-EU Manual De Instrucciones

PRODUCT FEATURES:

SPACIOUS DESIGN:
COMFORTABLY FITS UP TO SIZE 12/47 FOOT
TEMPERATURE CONTROL BUTTON
SPLASH GUARD AND
HANDLE TO EASILY CARRY
THE FOOTSPA AROUND
MASSAGE ROLLERS X4:
ROLL BENEATH YOUR FEET FOR
A DEEP PENETRATING FOOT
MASSAGE
ACU-NODES: STIMULATE THE
ACUPRESSURE POINTS ON THE SOLE
OF YOUR FOOT.
INSTRUCTIONS FOR USE:
1. Ensure that the unit is unplugged before filling with water. Fill with warm water to the MAX fill line located on the inside of the tub.
2. Place the unit on the floor in front of a chair. It is recommended to place the product on a towel.
3. Plug the unit into a 220-240 AC power supply.
4. Sit down and place your feet in the water.
5. To turn the unit on, press the power button
once.
6. To select the temperature, press the heat button
Note: For best results always start with warm water in the footspa.
7. Enjoy a deep massage by sliding feet back and forth over the stimulating raised massage nodes on the footspa floor.
8. Move your foot over the exfoliating pumice stone to smooth the skin.
9. To use the bath salt dispenser, pull the dispenser from the footspa. Twist the pumice stone lid in a clockwise direction to remove it. Place the bath salts
inside the dispenser and twist the top on again. Place back in the footspa pushing it firmly onto the locator.
10. To turn the footspa off, press the on button again.
11. To empty: First, unplug the unit. Tip the unit, allowing water to pour out of the corner furthest from the control panel.
DO NOT pour water over the control panel.
MAINTENANCE:
Cleaning
• Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly damp sponge.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
• Periodically straighten cord if it becomes twisted.
Storage
Place the appliance in its box or in a safe, dry, cool place.
DO NOT wrap the power cord around the appliance.
DO NOT hang the unit by the cord.
TEMPERATURE (ºC)
POWER BUTTON
. The bubble function will start automatically. To turn the bubble function off, press the bubble button
. Keep pressing to reach the desired temperature (between 35º to 48º degrees).
GB
2 I
BUBBLE BUTTON
MAX FILL LINE
BUBBLE SPA: ENJOY A SOOTHING AND
REJUVENATING BUBBLE MASSAGE
PUMICE STONE FOR EXFOLIATION
BATH SALT DISPENSER