Publicidad
Idiomas disponibles
Idiomas disponibles
2
6. Disconnect throttle cable end from carburetor throttle plate
(F).
7. Disconnect insulated ignition stop lead connectors (G).
8. Remove ignition ground lead terminal screw and disconnect
ground lead (H).
9. Cut plastic wire tie securing spark plug lead and ground
wires.
10. Remove 3 throttle arm mounting screws, nut (S), and
washers (I,J,K), and remove throttle arm assembly (L) from
blower frame.
i
nsTallaTion
1. Install new throttle arm assembly (L) to blower frame using 3
mounting screws, nuts, and washers.
2. Connect ignition ground lead ring terminal using ground lead
screw (H).
3. Connect insulated ignition stop lead connectors (G).
4. Position throttle cable adjustment nut (M) 9 mm (11/32 in.)
from end of threaded tube.
5. Slide rubber dust cap (N) down over end of threaded tube.
6. Connect throttle cable end to carburetor throttle plate (F).
7. Install carburetor (D) and air filter case (E).
8. Place throttle cable adjustment nut and fuel lines in retainer
clamp (C), and attach to blower housing using screw. Make
sure adjustment nut is fully seated in hex recess before tight-
ening clamp screw.
9. Secure ground wires to spark plug lead using plastic wire tie.
10. Install engine cover (B).
11. Install air filter and air filter cover (A).
12. Connect spark plug wire to spark plug.
13. Start unit, and check throttle control and stop switch for
proper operation.
H
T
K
ip
HroTTle
i
:
nsTrucTions
i
i
iT
nsTallaTion
nsTrucTions
H
d
F
e
c
L
i,j,K
M
9
MM
G
d
F
N
Publicidad
