Echo 99944200561 Instrucciones De Instalación

YOU MUST INSTALL THE U-HANDLE WHEN USING BRUSH OR CLEARING BLADES. A METAL
SHIELD IS REQUIRED FOR ALL BLADE USE. You must read and understand the Operator's Manual and
Trimmer/Brushcutter Safety Manual before installing or using this kit. Failure to follow all instructions, or operation
without specified shield, handle, and harness, can result in serious personal injury. The type of blade used MUST be
matched to the type and size of material cut. An improper or dull blade can cause serious personal injury. Blades
MUST be sharp. Dull blades increase the chance of kickout and injury to yourself and bystanders.
For Models:
INSTALL METAL SHIELD
Tools Required: 8mm x 10mm Open End Wrench, Screwdriver.
Parts Required: Metal Shield, Bracket, 3 - 5mm x 15mm screws
w/captivated flat and lockwasher (metal shield to gear housing),
2 - 5mm x 8mm screws, 4 - 5mm nuts, 4 - 5mm lockwashers (bracket to
shield and bracket to gear housing).
1. If necessary, remove nylon line head and plastic shield.
2. Loosely attach bracket (A) to shield (B) and attach to bottom of
gear housing (C) with screws and nuts provided. Tighten all
attaching hardware.
Install Blade
Tools Required: Locking Tool, scrench.
Parts Required: 1 - 20mm Upper Plate, Grass Blade (69600120330),
Brush Blade (69500120330) or Tri-Cut Blade w/Glide Cup (99944200030),
1 - Lower Fixing Plate, 1 - 10mm L.H. Nut, 1 - 2x22mm Split Pin.
3. Install upper plate (D) on splined shaft. Blade installation requires
use of upper Plate (D) with 20mm pilot. Upper plate with 37mm
pilot should be retained for use with nylon line head.
4. Place Blade (E) over upper plate pilot, install the lower Plate (F)
and 10mm LH nut (G). Tri-Cut Blade (H) is installed with Glide
Cup (J).
5. Insert Locking Tool (K) through hole in upper plate and notch in
gear housing to prevent splined shaft from turning. Tighten nut
and secure with Split Pin (L).
X7502098000
INSTALLATION INSTRUCTIONS
U-HANDLE COMBO KIT
U-HANDLE COMBO KIT P/N 99944200561
WARNING
SRM-260 S/N 03001001 - 03999999
SRM-261 S/N 02001001 - 02999999
SRM-260S S/N 03001001 - 03999999
SRM-261S S/N 02001001 - 02999999
SRM-311 S/N 02001001 - 02999999
SRM-311S S/N 02001001 - 02999999
DANGER
NYLON HEAD
UPPER PLATE
BLADE UPPER
PLATE
X750002980
11/05