Authorized KICKER Dealer:
Purchase Date:
Subwoofer Model Number:
Subwoofer Serial Number:
SPECIFICATIONS
Model
Nominal Impedance [Zn], ohm
Resonance Frequency [fs], Hz
Power Handling Watts, Peak (RMS)
Sensitivity [SPLo], dB @ 1W, 1m
DC Resistance [Re], ohm
Mechanical Q-Factor [Qms]
Electrical Q-Factor [Qes]
Total Q-Factor [Qts]
Equivalent Volume [Vas], ft³ (L)
Outer Frame Diameter, in (cm)
Hole Cut-Out Diameter, in (cm)
Mounting Depth, in (cm)
Note: All specifi cations and performance fi gures are subject to change. Please visit www.kicker.com for the most
current information. To get the best performance from your new KICKER Subwoofer, we recommend using genuine
KICKER Accessories and Wiring. Please allow two weeks of break-in time for the subwoofer to reach optimum
performance.
WIRING
Solo-Baric L3 subwoofers are available with dual 2 (ohm) or dual 4 voice coils. Both coils must be
connected to a source of amplifi cation. The dual 2 woofer will generate a 1 load if the coils are wired
in parallel or a 4 load in series. The dual 4 woofer will provide a 2 load wired in parallel or 8 load
wired in series. The terminals with the white dots are for the fi rst voice coil. The terminals with solid-red
and solid-black markings are for the second voice coil. See Figure 1.
Sound Check: Poor bass response? Check the system phasing by reversing the positive and negative
speaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase in
reference to the rest of the audio system.
2
2011 L3 Multilingual Rev B.indd 2
2011 L3 Multilingual Rev B.indd 2
Models:
S10L3
2 or 4
32.85
800 (400)
85.3
3.9
9.078
.657
.612
1.44 (40.81)
10-11/16 (27.1)
9-5/16 (23.7)
5-1/2 (14)
SOLO-BARIC L3 SUBWOOFER
OWNER'S MANUAL
S10L3 / S12L3 / S15L3
S12L3
2 or 4
31.37
800 (400)
86.3
3.9
9.198
.796
.733
2.5 (71.06)
12-5/8 (32)
11-1/16 (28.1)
6-1/4 (15.8)
S15L3
2 or 4
24.57
1000 (500)
90.292
3.8
9.881
.438
.419
7.24 (204.94)
15-5/8 (39.7)
13-3/4 (34.9)
8-1/8 (20.6)
10/19/2010 2:08:25 PM
10/19/2010 2:08:25 PM