Uline H-8367 Instrucciones De Montaje página 4

13. Place desktop (1) and return top (2) upside down
on a smooth, non-marring surface to prevent
scratching. Grommets should be facing down.
14. Place adjustable table frame (3) and adjustable return
frame (4) on top of desktop (1) and return top (2).
Position frame so that it is centered on the desktop
and return top. (See Figure 9)
NOTE: Adjustable frame is designed to fit
60 x 60" and 72 x 72" tops. Extend the frame
as needed to position desktop.
For 60 x 60" L-Desks, top support brackets
should be approximately 3" from side edges of
desktop and approximately 2⁄" from front and
back edges of desktop. Top support bracket
of return frame will be approximately 1⁄" from
rear edge and 3" from front edge of return top.
For 72 x 72" (24" deep) L-Desks, top support
brackets should be approximately 6" from side
edges of desktop and approximately 2⁄" from
front and back edges of desktop. Top support
bracket of return frame will be approximately
1⁄" from rear edge and 3" from front edge of
return top.
For 72 x 72" (30" deep) L-Desks, top support
brackets should be approximately 6" from side
edges of desktop and approximately 5⁄" from
front and back edges of desktop. Top support
bracket of return frame will be approximately
4⁄" from rear edge and 6" from front edge of
return top.
15. Attach top support brackets (6), adjustable table
frame (3) and adjustable return frame (4) to desktop
using drill and thirteen 5 x 20 mm wood screws (13).
Attach mounting plates (19) using 12 M4 x 20 mm
wood screws (18) to connect desktop and return top.
(See Figure 9)
Figure 9
18
2
19
PAGE 4 OF 23
ASSEMBLY CONTINUED
13
1
16. Place programmable handset (8) in desired location
on front edge of desktop (1). Attach using a drill and
two 5 x 20 mm wood screws (13). (See Figure 10)
Figure 10
8
17. Connect the power to the control box (7) using
the power cord (10). Connect the programmable
handset (8) and lifting column cables into the
control box (7). (See Figure 11)
7
10
13
Figure 11
8
Lifting Column
Cable
1120 IH-8367