Transport And Storage; Technical Data - Tunturi E 2 Manual Del Usuario

TRANSPORT AND STORAGE ::

Follow these instructions when carrying and moving the cycle about,
because lifting it incorrectly may strain your back or risk other accidents:
Stand behind the device. Grip the seat with one hand and the handlebar
with the other, and set your foot on the rear support. Tilt the device so
that it rests on its transport wheels. Wheel the device to move it on these
transport wheels. Lower the device while holding on to the handlebar and
remain behind the device all the time.
If the device is not used for a period of time, the transmission belt may
become temporarily distorted. This can lead to slightly uneven pedalling.
However, after a few minutes of use the effect disappears as the belt
returns to its original form.
To prevent the cycle malfunctioning, store in a dry place with as little
temperature variation as possible and protected from dust.
MAINTENANCE ::
The equipment requires very little maintenance. Check, however, from
time-to-time that all screws and nuts are tight.
:: After exercising, clean the equipment with a soft, absorbent cloth.
Sweat may cause corrosion: we recommend therefore that you
protect all metal surfaces outside the plastic covers with tefl on or
car wax. Do not use solvents. The magnetic brake is
based on magnetic resistance; resistance level is measured
electronically and shown as a watt-reading on the display.
:: Due to the measurement system, your Tunturi ergometer need not
be recalibrated when assembled, serviced and used according to
this owner's manual.
If the meter display shows text "LO BAT", change the batteries. Loosen
the 6 fastening screws in the top of the meter. Carefully lift the top, cut
the ribbon over the batteries and remove the old batteries. Place the new
batteries (3 x 1.5 V AA) in the holder and replace the top of the meter.
10 ::
If the display malfunctions proceed as follows:
Loosen the 6 fastening screws in the top of the meter. Carefully lift the
top and turn it so that the wire joint is exposed. Detach the joint by
pressing the lever towards the wire and pull the wire connector out. Be
careful not to let the wire drop inside the tube. If the bottom of the
meter is damaged, remove it by unscrewing the 2 fastening screws at the
bottom. Defective parts should be sent to your Tunturi dealer. Ensure
that the meter wire is securely locked in place when replacing the top of
the interface by gently pulling on the joint.
NOTE! Despite continuous quality control, defects and malfunctions
caused by individual components may occur in the equipment. In most
cases it is unnecessary to take the whole device in for repair, as it is
usually suffi cient to replace the defective part. If the equipment does not
function properly during use, contact your Tunturi dealer immediately.
Always give the model and serial number of your equipment. The
location of the serial number sticker is shown on the inside cover. Please
also state the nature of the problem, conditions of use and purchase date.
If you require spare parts for your equipment, please contact your dealer
with the model, equipment serial no. and spare part number of the
required part. There is a spare part list at the back of this manual. Use
only components and parts mentioned in the spare part list.

TECHNICAL DATA ::

Length 96 cm
Width 69 cm
All Tunturi models and user interfaces meet the requirements of the
EU EMC Directives on electromagnetic compatibility (89/336/EEC)
and electrical equipment designed for use within certain voltage limits
(73/23/EEC). This product therefore carries the CE label.
All Tunturi ergometers meet CEN precision and safety standards (Class
A, EN-957, parts 1 and 5).
Height 124 cm
Weight 35 kg
:: 11