Verifying Proper Installation For Windows Xp With Service Pack 1 - Belkin F5U508 Manual Del Usuario

Installation
4. Insert the PCI Card into the slot. Apply pressure as needed until the Card is
5. After installing the PCI Card, replace the outer cover and turn on the
6. When Windows restarts, the PCI Card will be detected and install drivers
EN
Note: Depending on the speed of your computer, it may take up to 45 seconds
for the PCI Card to be detected.

Verifying Proper Installation for Windows XP with Service Pack 1

After installation, check the Device Manager to confirm that the PCI Card has
been properly installed.
1. Right-click on "My Computer".
2. Select "Properties".
3. Select the "Hardware" tab and click on the "Device Manager" button.
The "Universal Serial Bus Controllers" list will now include two "ALI to USB
Open Host Controller" entries, one "ALI to USB Enhanced Host Controller"
entry, one "USB 2.0 Root Hub Device" entry, one "Standard Enhanced PCI to
USB Host Controller" entry, and two "USB Root Hub" entries.
18
5248ea-A_F5U508ea.indb 18
fully seated. Secure the PCI Card with the screw removed in step 3.
computer.
for two "Ali PCI to USB Open Host Controller" entries, one "Standard
Enhanced PCI to USB Host Controller" entry, one "USB 2.0 Root Hub"
entry, two "Root Hub" entries, and one "OHCI Compliant IEEE 1394 Host
Controller" entry.
14/2/07 9:08:51 am