GE 21 Serie Manual De Proprietário página 27

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

H. Remove the button plugs on the left side of
the cabinet across from where the hinge
bracket was located and install in the holes
where the bracket was removed.
I. Flip the center hinge
bracket and install
on the left side of the
cabinet where the
button plugs were
removed.
J. Using a 1/4" Allen
wrench, install the
hinge pin into the
center hinge bracket.
For Models With a Freezer DOOR:
F. Tape the freezer door shut with adhesive
tape.
G. Using a 1/4" Allen
wrench, remove the
hinge pin from the
hinge bracket. The
hinge pin will be
used again on the
opposite side.
H. Remove the tape and tilt the door away
from the cabinet. Lift the door off of the
bottom hinge pin.
I. Using a thing-blade screwdriver remove the
button plug from the top left side of the door
and install it on the opposite side.
J. Set the door on a non-scratching surface
with the inside up.
Installation Instructions
K. Using a 5/16"
socket/ratchet
driver, remove
the bolts
securing the
center hinge to
the cabinet.
L. Locate the
button plugs in the kit and install them in
the opposite side of center hinge.
M. Flip the center hinge
bracket. Using a 5/16"
socket/ratchet driver,
install the center hinge
bolt on the left side of
the cabinet and torque to
60 in-lb.
N. Using a 1/4" Allen wrench, install the hinge
pin into the center hinge bracket. Do not let
the pin go past the bottom of the bracket.
O. Using a 5/16" socket/ ratchet driver, remove
the screws from
the bottom hinge
bracket. These will
be reinstalled on the
other side. Pull up
on the hinge pin to
remove.
P. Using a Torx T-20
screwdriver, remove the
screw from the cabinet
and install it on the
other side.
Q. Using 5/16" socket/
ratchet driver,
install the bottom
hinge bracket
and torque the
screws to 60 in-lb.
Remount the hinge
and pin in the
opposite hole on
the cabinet.
27

Publicidad

Tabla de contenido
loading

Tabla de contenido