LUND I-20250 Manual De Instrucciones página 4

Vehicles without Tow Hooks, closed end of frame
a. Starting on the driver side of the vehicle, locate the two holes on the bottom of the frame.
Insert (1) 10mm U-Bolt into one hole and out the other, (Figures 7A & 7B).
(Fig 7A) 10mm U-Bolt
b. Hold the driver side Bracket up in position with the slotted end toward the rear. Secure the
Bracket to the U-Bolt with (2) 10mm Flat Washers and (2) 10mm Nylon Lock Nuts,
(Figure 8).
10mm U-Bolt
(2) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
c. Snug but do not tighten the hardware.
d. Repeat to install the passenger side frame Bracket.
Insert 10mm U-Bolt into one
hole and out the other. (U-Bolt
is only used on vehicles with
"closed end frames")
Front
(Fig 7B) Example of a "closed end
of frame" installation pictured
Fig 8
Page 4 of 6
I-Sheet Number I-20250 Rev.A
REVOLUTION BULL BAR
Example of a "closed
end of frame" pictured
04-17 F-150
11/16/16