LUND I-20250 Manual De Instrucciones página 6

Models without openings in lower bumper or splash guard for tow hooks. Hold the cover up to
the bottom of the bumper, (Figure 12A). Trace the location of both Brackets onto the back of the
cover. Temporarily remove the Bull Bar with attached Tube Brackets only. Cut openings in the
cover to clear the Frame Brackets and end of Bull Bar as necessary, (Figure 12B). For best results,
start with a small slot and slowly enlarge the opening to clear the Brackets. Once cover is properly
fit to the Brackets, reinstall the cover and Bull Bar as previously described.
Front
Fig 12A
Front
(Fig 12B) Only cut enough to clear the Brackets, do not
cut through the front or rear edges of the cover.
™
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2016 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Page 6 of 6
I-Sheet Number I-20250 Rev.A
Hold the splash guard up to the bottom of the
Brackets. Trace the location of the Brackets onto
the inside of the splash guard. Use a sharp knife
or hacksaw blade to cut out the plastic cover.
Only cut enough to clear the Brackets, do not cut
through the front or rear edges of the cover.
REVOLUTION BULL BAR
04-17 F-150
11/16/16