LUND I-20250 Manual De Instrucciones página 5

2. Next, carefully unwrap the Bull Bar. Select the driver side Bull Bar Mounting Bracket, (Figure 9). Attach
the Bracket to the end of the Bull Bar with (2) Bolt assembly (Figures 10A & 10B). Center the mounting
flange on the Bracket with the end of the tube on the Bull Bar. Snug but do not tighten hardware.
Repeat this Step to install the passenger side Mounting Bracket.
(Fig 9) Driver side tube
Mounting Bracket
3. With assistance, line up the mounting tabs on the Bull Bar with the inside of the (2) previously installed
Frame Mounting Brackets. Bolt the Bull Bar to the Brackets with the included (4) 10mm x 35mm Hex
Bolts, (8) 10mm Flat Washers, (4) 10mm Nylon Lock Nuts, (Figure 11). Snug but do not tighten
hardware at this time.
4. Level and adjust the Bull Bar properly and tighten all hardware.
Fig 10A
Fig 11
Page 5 of 6
I-Sheet Number I-20250 Rev.A
REVOLUTION BULL BAR
Bolt
Fig 10B
Assembly
(2) 10mm x 35mm Hex Bolts
(2) 10mm Flat Washers
(2) 10mm Nuts
04-17 F-150
11/16/16