Storing The Mower; Replacing The Battery - Ryobi RLM4852L Traducción De Las Instrucciones Originales

EN
DE
FR DE ES IT
FR EN ES IT
Deutsch (Übersetzung der originalen Anleitungen)
10. Torque the blade nut down clockwise using a torque
wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut
is 62.5~71.5 kgfcm (350-400 in.-lb.).
To reduce the fi re hazard, keep the motor and battery
compartment free of grass, leaves, or excessive grease.
DRIVE GEAR MAINTENANCE
See fi gure 16.
To ensure smooth operation of wheels, the wheel
assembly should be cleaned before storage.
1. Remove the nut by turning counter clockwise. Remove
wheel and set aside.
2. Remove dust cover, e-ring, washer, pins, and wheel
gear. Clean any dirt from these items and the end of
the drive shaft by wiping with a dry cloth. If necessary,
rubbing alcohol may be used to remove any stubborn
dirt.
3. Reinstall wheel gear with the arrows facing the front
of the mower. Reinstall pins, washer, e-rings, and dust
cover.
4. Reinstall wheel and nut. Tighten nut clockwise to
secure.
REPLACING FRONT WHEELS
See fi gure 17.
1. Using a hex wrench (not provided), remove the hex
nut by turning counterclockwise.
2. Remove the wheel and replace with new wheel.
3. Replace the hex nut and tighten securely by turning
clockwise.

STORING THE MOWER

See fi gure 2.
■ Remove the isolator key and store in separate location
out of reach of children.
■ Removal of the battery is not required for storage.
■ When the battery pack is not in use, store it in an
environment of 25 ˚C and recharge it every 2 months.
■ Before storage, wipe any dirt or debris from the battery
area.
■ Turn mower on its side and clean grass clippings that
have accumulated on the underside of the mower
deck.
■ Wipe the mower clean with a dry cloth occasionally.
Do not use water.
■ Check all nuts, bolts, knobs, screws, fasteners, etc.,
for tightness.
■ Inspect moving parts for damage, breakage, and
wear. Have repairs made on any damaged or missing
parts. Check blade for damage, uneven, or excessive
wear and replace blade if these conditions exist.
PT NL SV DA NO FI
PT NL SV DA NO FI
English (Original instructions)
HU CS RU RO PL
HU CS RU RO PL SL
■ Store mower indoors in a clean, dry place out of the
reach of children.
■ Do not store near corrosive materials such as fertilizer
or rock salt.
To lower the handle before storing:
1. Fully loosen the handle knobs on the sides of the
handle and fold the upper handle down.
2. Push inward on each side of the lower handle, and
lift the sides of the lower handle past the edges of the
handle mounting brackets. Avoid pinching or trapping
any cables.

REPLACING THE BATTERY

See fi gure 18.
The mower battery is designed for maximum life; however,
like all batteries, it will eventually need to be replaced.
Charge the new battery pack before use. See charging
the battery pack in the operation section of this manual.
To install a new battery:
1. Remove the isolator key.
2. Carefully lift the old battery by the handle.
3. Install the new battery pack.
4. Take the old battery pack to a recycling center that
accepts lead acid/lithium ion batteries. Never dispose
of battery in fi re or regular household trash.
22 22
SL HR ET LT LV SK BG
HR ET LT LV SK BG