Back Fabric Replacement - Steelcase Cura II Instrucciones De Montaje

®
HEALTH

Back Fabric Replacement

1.
Place chair upright. Slide seat frames
toward center of chair. A rubber mallet
can be used for this step.
2.
Using two (2) hands, gently pull
upward on the back fabric to remove.
BACK
FABRIC
3.
When installing the new back fabric, there will be
tension from the two (2) back rods. This is normal.
Secure one end of back fabric to back rod (3a). Pull
on the other end of the back fabric, while pushing
inward on the other rod (3b). Place back fabric onto
seat rod.
REPLACEMENT
BACK FABRIC
3b
2
4.
Using two (2) hands, gently slide back fabric
downward.
If you have completed the replacements in this
chair, go to 'Add the Tension into the Chair'.
3a
BACK
ROD
4
Page 4 of 30
939549932 Rev C