Leister GEOSTAR G5 LQS Manual Del Usuario página 7

8
Connect GEOSTAR with the app.
9
Synchronization
status display
10
After this, completely switch off the GEOSTAR. Power
interruption > 6 sec.
12
The warning triangle in the status bar is gone, and
the free space on the SD card is also again greater
than 0MB.
If there is a WIFI connection between GEOSTAR
and the app, synchronize the welding data.
Attention! It is not necessary to also synchronize
the entire welding archive.
11
The SD-Card should now work as usual upon the next
startup.
7