Advanced Programming Options; Changing/Holding The Temperature; Advanced Programming Parameters In Variable Table - Carrier Comfort Module Serie Manual De Instrucciones

Advanced Programming Options

Changing/Holding the temperature

You can temporary change temperature setting. It works
only in own zone , or using Par. 1 of Variable Table.
1. Open the lid.
2. Use zone button be sure to be in own zone
3. Press up or down buttons to set the new temperature
set point. This creates a "temporary hold" until the
next pre-set time period. You will see schedule active
icon ( ) flashing on the display.
4. To maintain that temperature set point then the
schedule, press hold ( ) button. The schedule active
icon ( ) will disappear.
5. To return back to the schedule setting, press hold
( ) button. This releases the hold and the
temperature will return to temporary level. The
schedule active icon (
6. Close the lid.
Note: The feature works only if part 1.11 is set to 0. Otherwise
it's not possible to change the room temperature set point.

Advanced programming parameters in variable table

To access and manage the parameters in variable table
follow the steps below.
1. Open the lid.
2. Press and zone key
seconds. You will see parameter number "1" is flashing
in the time display area.
3. Press mode button, you will see parameter value
will be flashing in the temperature display area of the
display.
4. Press up or down buttons to change the settings to
your desired value.
5. If the parameter has sub-parameters, use
use to switch between them. Use arrow keys to
select the desired value.
10
.
) will blink.
buttons and hold for 3
key, then