Special Features; Short-Cut To Silent Mode; Keyboard Lock; What If - Carrier Comfort Module Serie Manual De Instrucciones

Advanced Programming Options
6. Press the mode button to save settings and enable
the next parameter to be changed. The parameter
number will be flashing.
7. Press up and down button to go to the next
parameter.
8. You can program all your parameters by following
the same procedure. Once you completed, press OK
button to save your settings and will return to the
normal display screen.
9. Close the lid.
10. For setting parameters of virtual zones, use the virtual
zoning concept, then follow the same procedure.
Note: Refer to parameters table in the main unit
documentation for more details.

Special Features

Short-Cut to Silent Mode

Press the Hold ( ) key for 10 seconds to make Silent mode
active. Deactivate Silent mode by pressing the Hold ( ) key
again for 10 seconds.
When Silent mode is active, NUI will display the (
Icon. If Silent mode is active, this will always override the

Keyboard Lock

To Lock all key and block command functions.
1. Open the lid.
2. Press and hold for 3 seconds the three buttons days
( ), period ( ) and start time (
3. All the keys will be disabled and the lock icon ( ) will
be visible on display.
4. To unlock the keyboard press again the three buttons
for 3 seconds. The lock icon ( ) will disappear.

What If !

Fault Code Table

In case of system failure, the alarm icon (
Failures are identified by a fault code.
Active fault codes will be displayed in sequence, with a
change rate of 1 second, on Par. 6 of variable table. On Par. 5
selection done in program schedule.
This procedure works only on master user interface.
Otherwise use virtual zoning, connecting to address 10
(master board) and changing the variable table Par. 109.0.
)
).
it's possible to see the addressers of the devices in failure.
) will light up.
Refer to the main unit documentation for a description of
the fault codes.
11