Sauder Heritage Hill 109848 Instrucciones De Montaje página 12

Step 8
Fasten the MODESTY PANEL (D) to the 109843 Top as
å
shown. Tighten the TWIST-LOCK® FASTENERS in the
MODESTY PANEL.
NOTE: If you pushed TWIST-LOCK® FASTENERS into
å
the wrong holes in the MODESTY PANEL, pull the
FASTENERS back out of the holes and insert them into
the proper holes. Pull at the front and back edges, slowly
working the FASTENERS out of the holes.
Fasten the 109843 Left Upright to the MODESTY
å
PANEL (D). Use the two 1-7/8" FLAT HEAD SCREWS you
removed in step 5 through the inside of the Left Upright
and into the edge of the MODESTY PANEL.
Page 12
RETURN KIT(S) ON RIGHT
S T E
® F A
C K
- L O
I S T
T W
i t h
e w
D
f a c
S u r
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
1 0
9 8
S
L e
N E R 4 3
f t
U p
r i g
h t
109848
®
FASTENER
BLACK 1-7/8" FLAT HEAD SCREW
(2 used in this step, removed in step 5)
www.sauder.com/services