Mopar 82212423AB Instrucciones De Montaje página 20

20
UPDATE PRESSURE THRESHOLDS
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The vehicle must be driven before the TPMS light will turn off.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "TIPMCGW"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight and select "UPDATE PRESSURE THRESHOLDS"
• Note On­Screen instructions and select the "NEXT" button
• Verify current settings, select the "NEXT" button to change settings
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified, select "NEXT"
• Select "NEXT"
• Wait for the WCM/WIN to update it's configuration
• Once the WCM/WIN configuration is complete, select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
TEMPORARY REMOTE START DISABLE
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "TIPMCGW"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight and select "TEMPORARY REMOTE START DISABLE"
• Note On­Screen instructions and select the "NEXT" button
• Select the "DISABLE" button to activate the remote start function
• Select "YES" to reset the module and exit the routine, select "NO" to toggle the value back
• Select "FINISH"
CLEAR ALL DTC'S
NOTE: The wiTECH diagnostic application is the preferred method for clearing all DTC's.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
ACTIVATE THE REMOTE START
To activate the remote start the vehicle must have been driven at least 35 MPH.
With the vehicle off, and the doors closed and locked, verify the remote start is functioning properly.
4280312
Jun 21, 2010 K6861080