DeWalt D28474 Manual De Instrucciones página 37

3. Maintain a 5˚ to 10˚ angle between the tool
and the work surface.
4. Continuously move the tool in a forward and
back motion to avoid creating gouges in the
work surface.
5. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before setting it down.
Mounting and Using Cutting
(Type 1) Wheels
Cutting wheels include diamond wheels and abrasive discs. Abrasive
cutting wheels for metal and concrete use are available. Diamond
blades for concrete cutting can also be used.
WARNING: A closed, cutting wheel guard is not included with
this tool. Cutting wheels require proper flanges and guards. A 7"
(180 mm) cutting guard, is available as an accessory and includes
proper, matching flanges. Failure to use proper flange and guard can
result in injury resulting from wheel breakage and wheel contact.
MOUNTING CLOSED (TYPE 1) GUARD
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off. An
accidental start-up can cause injury.
1. Open the guard latch (H), and align the lugs
with slots on the gear case cover. Position
the guard facing backward, as shown.
2. Push the guard down until the guard lug
engages and rotates freely in the groove on
the gear case hub.
3. Rotate guard (Q) into desired working position. The guard body
should be positioned between the spindle and the operator to
5˚-10˚
provide maximum operator protection.
4. Close the guard latch to secure the guard on the gear case cover.
You should be unable to rotate the guard by hand when the latch
is in closed position. Do not operate grinder with a loose guard or
clamp lever in open position.
NOTE: The guard is pre-adjusted to the dia met er of the gear case
hub at the factory. If, after a period of time, the guard be comes loose,
tighten the adjusting screw (I) with the clamp lever in the closed
position.
CAUTION: Do not tighten adjusting screw with clamp lever in
open position. Undetectable damage to guard or mounting hub may
result.
MOUNTING CUTTING WHEELS
1. Remove soft mount (F).
2. Install wheel backing flange, aligning flats on spindle (O) with flats
on backing flange (R).
H F
35
Q
I
O
R