Assembly And Adjustments - DeWalt D28474 Manual De Instrucciones

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off. An
accidental start-up can cause injury.
ATTACHING THE SIDE HANDLE
To install the side handle, thread the
handle into one of the five positions listed
below and tighten securely by turning
clockwise.
• Two front positions: Forward
handle positions are designed for
optimized balance in surface finishing
applications.
• Two rear positions: Rear handle
positions are designed for optimized
balance in edge grinding applications.
• One top position: Top handle
position is designed for edge grinding applications.
NOTE: D284076 includes only three handle positions.
ROTATING THE REAR HANDLE
1. Unlock the rear handle by
pulling out the handle
re lease lever (M) as shown.
2. Rotate handle into available
0°, 30°, 60° or 90° position
left OR right of center.
3. Push in the handle release
lever.
NOTE: Wheel size must match guard size; i.e., a new 7" (180 mm
wheel may not be used with a 9" (230 mm) guard. The bottom
surface of wheel must be inside the bend of the guard lip.
M
27
Sanding Flap Disc
soft mount soft mount
Type 27 guard Type 27 guard
backing flange
hubbed sanding
flap disc
non-hubbed sanding
flap disc
clamp nut