Disposal And Recycling; Maintenance And Storage; Trouble-Shooting - STERWINS 135HR EPW.3 Manual De Instrucciones

7. DISPOSAL AND RECYCLING

Waste Disposal and Environmental Protection!
Be environmentally friendly. Return the tool, accessories and packaging to a
recycling center when you have finished with them.
Electrical machines do not belong in domestic waste.
Take the equipment to a waste disposal site. The plastic and metal parts that are
used can be separated out into pure grade, which allows recycling.

8. MAINTENANCE AND STORAGE

Any maintenance operations not covered by this chapter should be carried out by an Authorized
Sales and Service Centre.
Caution!
Always disconnect the plug from the power sources before carrying out any work
on the appliance.
• Cleaning the nozzle
--Disconnect the nozzle from the lance.
--Remove any dirt deposits from the nozzle hole using the cleaning pin.
• Cleaning the filter
Inspect the intake filter and detergent (if fitted) before each use, and clean in accordance with
the instructions.
STORAGE AND TRANSPORT
Storage
Store the machine in a dry and well-ventilated place.
When placing the machine out of service for an extended period of time, remove the cleaning
agent and drain all of the water left in the hoses.
Transport
If shipping, use the original packaging wherever possible.
DISPOSAL
Disposing of the machine
Machines which are labeled with the adjacent symbol must not be disposed of with household
rubbish. You must dispose of such old electrical and electronic appliances separately.
Please check the disposal options with your local authority. Old equipment that is disposed
of separately is sent for recycling or for other forms of re-use. This helps to prevent damaging
materials from being released into the environment.
Disposing of the packaging
The packaging consists of cardboard and labeled sheets that can be recycled. Please recycle
these materials.
EN
150
1) No power.
• Check the plug socket, cable, line and plug, where appropriate, have repaired
through electrical specialist.
• Any of the parts are defective, such as On/Off switch /motor etc. (please contact
service agent).
2) The high pressure washer operates intermittently.
• Power cable is damaged.
• Internal loose electrical connection.
• On/Off switch defective(please contact service agent).
• Nozzle is clogged. Clean dirty from the nozzle opening using the nozzle cleaner
provided .
3) No or only little pressure is built up.
• Check if there is any air in the system, if so, please ventilate the machine! Run the
machine without the high-pressure hose connected until water starts leaking
without bubbles. Re-attach the high-pressure hose.
• Check all inlet pipes leading to the pump for leaks or clogs.
• Check the setting on the hand-held spray gun.
4) Great pressure varieties.
• Clean the high pressure jet nozzle
• Check the water inlet pressure.
5) Machine pulsating
• Check if there is any air in the hose or pump,allow machine to run with open
trigger until regular working pressure resumes.
• Check if there isinadequate supply of mains water,avoid using long, thin hoses(min
1/2'').
• Check if nozzle partially blocked or water filter blocked,clean the nozzle or filter.
• Check if the hose kinked,straighten out hose.
6) Machine is leaking.
• Please contact the authorized agent.
151

9. TROUBLE-SHOOTING

EN