DoorBird D11x Manual De Instalación página 8

Only for D1101V & D1102V
We offer additional wall-mounting kits for D1101V
and D1102V Surface-Mount with a wedge corner
wall-mount adapter (7.5° vertical down or up) and
alternatively an angle corner wall-mount adapter (45°
horizontal, mounts left or right).
A8001 Wedge corner
wall-mount adapter
(7.5°, mounts vertical
down or up), sold
separately
When choosing the assembly location, consider
the lighting conditions. Avoid direct sunlight, direct
backlight and reflective surfaces.
Do not expose the device to direct sunlight.
N OT IC E
The housing temperature can exceed the
maximum allowed temperature limit.
This can result in damage of electric and
mechanic components of the device and
injuries especially when touching exterior
parts of the device. White and bright silver-
colored front plates absorb less sunlight than
dark ones.
An image sensor must not be exposed to
N OT IC E
direct sunlight for an extended period of
time. Direct sunlight will "blind" the camera
and may permanently bleach the small color
filters on the image sensor chip.
Any defects caused by direct sunlight are not
covered by warranty.
8
A8002 Angle corner
wall-mount adapter
(45° horizontal, mounts
left or right), sold
separately
ASSEMBLING THE MOUNTING
4
HOUSING
The product is available as a surface-mounted and
flush-mounted version. In the flush-mounted version,
the front panel is slightly larger to better cover the
hole in the wall and the mounting housing (backbox)
is made entirely of metal instead of plastic.
If you use the flush-mounted housing, lever up the
wall accordingly.
If the wall of the house is not made of wood, you
should drill dowel holes 5 mm (0.19 in) in diameter in
the wall according to the drilling template and then
place the dowels provided into the boreholes.
If you must drill holes in a wall, insert screws
into a wall or lever up a wall, ensure that no
cables or mains (gas, water, etc.) are to be
found in the wall.
If the wall of the house is made of wood, dowels
are not normally required. There are special dowels
for assembling the device on an insulating wall, e.g.
Fischer insulating dowels.